T Nation

How to Make Test Suspension!?


#1

allright guys, i have some test base powder and now its time to start converting and i need some help, there is not much of information about converting test susp. but i was thinking it like this:

  1. i put some ba & bb in the breaker and then put it on a frying pan and let it heat a little while i put the powder in there and start mixing.

  2. i take the solution in the syringe and put it in the vial, and then i will add the sterile water in the vial.

  3. then i suck it out and filter this trough either .45um or .22um filter and put it back in the vial.

and then im ready to go?

i want to know if this is truly this simple? and some hints are very welcome too.


#2

dont put unsterile things into a sterile vial. it defeats the purpose. the solution should be filtered before being put in the vial. you dont have to pull it back out to add the sterile water. just remember to do your math.
So filter the solution into the vial. add Sterile Water and shake it like a polaroid. ready to go. or you can add it all(solution and sterile water) in the pan and then filter it into the vial.
it is pretty easy. just remember to do your math or else your dose will be messed up.- higg


#3

thanks man, so do you have a good idea on how much ba, bb and water i should use if im gonna make 100mg/ml @ 100ml?

i was thinking like 5ml ba, 15ml bb, and 70ml water and 10grams of test powder, this should be quite close to 100mg/ml?


#4

Just incase you didnt catch your little error - 10 grams of test powder does not necessarily take up 10 ml....


#5

yeah i know, but somewhat close, around 5-10ml unless im completely wrong.


#6

50mg/ml x 200ml, Test Suspension (10g)

BB = 10% = 20ml
PS80 = 0.25% = 0.5ml
Displacement Factor = 10g x 0.75ml = 7.5ml
Bac. Water = 200ml-DF-BB-PS80 = 172ml

  • Add the TNE to the BB and PS80 and stir for 5 mins or until saturated.
  • Add the Water, then begin to heat and slowly stir.
  • It will clump, but they will disperse as the heat is applied.
  • When clumps are dispersed, it may be steaming - but is finished.
  • Filter into sterile containers.

I have not used this recipe yet - but it will be the one i choose to try first.

By the way - there is a fucking ton of information on converting all sorts of AAS from powder form into the relevant preparations online - you just didnt look hard enough.

I also dont suggest you do this - because if finding out how to brew BEFORE actually getting your powder is too difficult, you will more than likely end up regretting using steroids.

JMO..

JJ


#7

i know how to homebrew, i done it few times, but with propionate and deca, and i also made deca and nolvadex, but i have never before brewed water base steroids, this ps80, can i use benzylbenzodate instead of it? it would be a pain in the ass to start ordering more supplies.


#8

You arrogant little shite - quoted;

"..yeah i know, but somewhat close, around 5-10ml unless im completely wrong.."

"..thanks man, so do you have a good idea on how much ba, bb and water i should use if im gonna make 100mg/ml @ 100ml..?"

"..this should be quite close to 100mg/ml..?"

Now - dont insult our intelligence by suggesting "..i know how to homebrew.."


#9

Watch out now, master brewer walking through.


#10

More like "Walking the mile.. walking the Greeeen mile.."